Multivariate optimization and comparison between conventional extraction (CE) and ultrasonic-assisted extraction (UAE) of carotenoid extraction from cashew apple

Carotenoids are an essential component of cashew and can be used in pharmaceuticals, cosmetics, natural pigment, food additives, among other applications. The present work focuses on optimizing and comparing conventional and ultrasound-assisted extraction methods. Every optimization step took place with a 1:1 (w:w) mixture of yellow and red cashew apples lyophilized and ground in a cryogenic mill. A Simplex-centroid design was applied for both methods, and the solvents acetone, methanol, ethanol, and petroleum ether were evaluated. After choosing the extractor solvent, a central composite design was applied to optimize the sample mass (59–201 mg) and extraction time (6–34 min). The optimum conditions for the extractor solvent were 38% acetone, 30% ethanol, and 32% petroleum ether for CE and a mixture of 44% acetone and 56% methanol for UAE. The best experimental conditions for UAE were a sonication time of 19 min and a sample mass of 153 mg, while the CE was 23 min and 136 mg. Comparing red and yellow cashews, red cashews showed a higher carotenoid content in both methodologies. The UAE methodology was ca. 21% faster, presented a more straightforward composition of extracting solution, showed an average yield of superior carotenoid content in all samples compared to CE. Therefore, UAE has demonstrated a simple, efficient, fast, low-cost adjustment methodology and a reliable alternative for other applications involving these bioactive compounds in the studied or similar matrix.     

One‐pot synthesis of a multi‐template molecularly imprinted polymer for the extraction of six sulfonamide residues from milk before high‐performance liquid chromatography with diode array detection

A highly selective molecularly imprinted polymer sorbent was synthesized and employed for the simultaneous determination of six sulfonamide antibiotic residues (sulfanilamide, sulfacetamide, sulfadiazine, sulfathiazole, sulfamerazine, and sulfamethizole) in milk samples. Multi‐analyte imprinted particles were used as a sorbent in solid‐phase extraction. Sulfonamides were separated on a high‐performance liquid chromatography column (Merck–Lichrospher RP18e, 5 μm 250 × 4 mm) and further identified and quantified by diode array detection. Several parameters including required loading of the molecularly imprinted polymer sorbent, mass of milk, volume, and type of elution solvent, as well as time for absorption and elution were investigated to obtain optimal experimental conditions. For comparison purpose, a non‐imprinted polymer was applied under the optimum conditions. The validation study according to the European Union Decision 2002/657/EC was based on the investigation of linearity, selectivity, stability, limits of detection and quantitation, decision limit, detection capability, trueness, precision, and ruggedness according to Youden's approach. The decision limit and detection capability values in the milk were achieved from 101.9 to 113.5 μg/kg and from 114.4 to 135.4 μg/kg, respectively, depending on the target sulfonamide drug. Finally, the optimized protocol was successfully applied to commercial milk samples and human breast milk.     

Separation and purification of scandium: From industry to medicine

Scandium and its compounds are used in many modern industrial fields due to its unique chemical and physical properties. It is mainly recovered from residues and wastes in the production of other metals. The exploitation of the ores and wastes could contaminate water and soil creating environmental problems. This paper discusses recent developments and tendencies in scandium separation, purification and preconcentration from different wastes, residues, environmental samples as well as in the production of radiopharmaceuticals for nuclear medicine, both in the laboratory and on the industrial scale. The period reviewed here mainly includes publications that have appeared, since 2010.     

Simultaneous determination of 75 abuse drugs including amphetamines,benzodiazepines, cocaine,opioids, piperazines,zolpidem and metabolites in human hair samples using liquid chromatography–tandem mass spectrometry

A liquid chromatography–tandem mass spectrometric method for the simultaneous determination of 75 abuse drugs and metabolites, including 19 benzodiazepines, 19 amphetamines, two opiates, eight opioids, cocaine, lysergic acid diethylamide, zolpidem, three piperazines and 21 metabolites in human hair samples, was developed and validated. Ten‐milligram hair samples were decontaminated, pulverized using a ball mill, extracted with 1 mL of methanol spiked with 28 deuterated internal standards in an ultrasonic bath for 60 min at 50°C, and purified with Q‐sep dispersive solid‐phase extraction tubes. The purified extracts were evaporated to dryness and the residue was dissolved in 0.1 mL of 10% methanol. The 75 analytes were analyzed on an Acquity HSS T3 column using gradient elution of methanol and 0.1% formic acid and quantified in multiple reaction monitoring mode with positive electrospray ionization. Calibration curves were linear (r ≥ 0.9951) from the lower limit of quantitation (2–200 pg/mg depending on the drug) to 2000 pg/mg. The coefficients of variation and accuracy for intra‐ and inter‐assay analysis at three QC levels were 4.3–12.9% and 89.2–109.1%, respectively. The overall mean recovery ranged from 87.1 to 105.3%. This method was successfully applied to the analysis of 11 forensic hair samples obtained from drug abusers.     

Analysis of F-53B,Gen-X,ADONA, and emerging fluoroalkylether substances in environmental and biomonitoring samples: A review

The persistent, bioaccumulative, and toxic properties of certain per- and polyfluoroalkyl substances (PFAS) raise concerns for environmental and human health. This has led to the gradual phase-out from production and commerce of some legacy PFAS. Fluoroalkylether compounds (ether-PFAS) are among the fluorinated alternative chemicals that are beginning to be reported in impacted and background environments. Extensive monitoring activities were conducted since 2015–2019 to bridge knowledge gaps on the environmental fate and effects of ether-PFAS including F-53B (6:2 chlorinated polyfluoroalkyl ether sulfonate [6:2 Cl-PFAES] and 8:2 Cl-PFAES), Gen-X (hexafluoropropylene oxide dimer acid [HFPO-DA]), and ADONA (dodecafluoro-3H-4,8-dioxanonanoate). In recent years, advances in nontarget screening using high-resolution mass spectrometry have revealed the identities of other infrequently monitored ether-PFAS. In this critical review, we provide an up-to-date inventory of the structures of ether-PFAS discovered in the recent literature. Their environmental occurrence, fate, and effects are discussed on a comparative perspective with some legacy PFAS such as perfluorooctanoic acid (PFOA) and perfluorooctane sulfonic acid (PFOS). Information on the methods employed for the quantitative and semi-quantitative analysis of ether-PFAS is also provided, including sample preparation and mass spectrometry analysis, analytical performance, and limitations. In particular, the compiled database of MS/MS fragment ions (n = 111) can be useful in spectrum interpretation of novel ether-PFAS. The concluding remarks open on possible research avenues and the challenges that remain to be addressed.     

Entropic effect implication for change in polymer coils swelling state in the demixing enthalpy recovery of aqueous poly(vinyl methyl ether) solutions

Time‐dependent demixing enthalpy recovery behavior of aqueous poly(vinyl methyl ether) (PVME) solutions exhibits distinct recovery characteristics in three concentration regions. The absence of recovery behavior below a water concentration of 38.3 wt % indicates that the PVME coil is in a globular state. The typically sigmoidal recovery behavior of demixing enthalpy above 38.3 wt % is ascribed to the reswelling of the collapsed polymer coils induced by the entropic effect. The increase in difference between the upper and lower limits indicates the continued swelling of the PVME coils. Above 65 wt %, a dominant diluting effect can be observed, and a much longer phase separation time is needed to reach the expected lower limit. In contrast, the recovery of demixing enthalpy in a wide range of water concentration (from 38.3 to 90 wt %) exhibits the same feature. The infrared spectroscopy results are in agreement with the above macroscopic differential scanning calorimetry results. © 2018 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019 , 57, 142–151     

Rapid and easy quantification of elemental sulphur in aqueous samples from biological reactors: the turbidimetric method revisited

Recent developments in wastewater treatment have led to a renewed interest to obtain elemental sulphur (S°) as a by-product from bioreactors. However, practical studies are limited by the gap of adequate analytical techniques for its determination. This paper provides a statistical study and matrix effect evaluation of an adapted spectrophotometric method for routine S° analyses in aqueous samples, based on a methodology previously described by Hart (1961). Four complex matrices were tested: domestic sewage and effluent samples from three different bioreactors. Tested performance criteria included linearity, matrix effect, limit of detection and quantification and S° recovery. Results were linear (R² = 0.99994) in the studied range (5 to 100 mg S° L^?1) and no matrix effect was observed. The accuracy was based on recovery values that varied from 100% to 106%. The colloidal S° separation and extraction protocol was also considered suitable for aqueous samples, reaching more than 99.0% of S° recovery.     

Liquid chromatographic determination of trace levels of nitrophenols in water samples after dispersive magnetic solid phase extraction

An efficient and fast dispersive magnetic solid phase extraction method was developed using MIL‐101(Cr)/poly (mercaptobenzothiazole)@magnetite nanoparticles for the preconcentration and determination of nitrophenols in river and rain water samples. High‐performance liquid chromatography‐Ultraviolet instrument was applied for the analysis of target nitrophenols. The effect of several variables on the extraction performance was explored via design of experiment approach. Limits of detection and linear dynamic ranges were attained in the range of 0.05–0.10 µg/L and 0.2–250 µg/L, respectively. The enrichment factors were in the range of 317–363. The precision (n = 3) of dispersive magnetic solid phase extraction method was in the range of 5.3–6.8%. Eventually, the method was utilized for the analysis of target nitrophenols in river and rain water samples.     

Validation of a HPLC/MS method for simultaneous quantification of clonidine,morphine and its metabolites in human plasma

A high‐performance liquid chromatography–tandem mass spectrometry method was developed and validated for the simultaneous quantification of morphine, morphine's major metabolites morphine‐3‐glucuronide and morphine‐6‐glucuronide, and clonidine, to support the pharmacokinetic analysis of an ongoing double‐blinded randomized clinical trial that compares the use of morphine and clonidine in infants diagnosed with neonatal abstinence syndrome. Plasma samples were processed by solid‐phase extraction and separated on an Inertsil ODS‐3 (4 μm) column using an 0.1% formic acid in water–0.1% formic acid in methanol gradient. Detection of the analytes was conducted in the positive multiple reaction monitoring mode. The range of quantitation was 1–1000 ng/mL for morphine, morphine‐3‐glucuronide and morphine‐6‐glucuronide, and 0.25–100 ng/mL for clonidine. Intra‐day and inter‐day accuracy and precision were ≤15% for all analytes across the quantitation range. Extraction recovery rates were ≥94% for morphine, ≥90% for M3G, ≥87% for M6G and ≥ 79% for clonidine. Matrix effect ranged from 85–94% for clonidine to 101–106% for M3G. The method fulfilled all predetermined acceptance criteria and required only 100 μL of starting plasma volume. Furthermore, it was successfully applied to 30 clinical trial plasma samples.     

Novel thionin-functionalised core shell magnetic nanoparticles for dispersive solid-phase extraction of Hg(II) in food and water samples

To develop an accurate and precise method for separation and pre-concentration of Hg(II), a novel thionin functionalised core shell structure magnetic material has been prepared and characterised. The extraction ability of the material was evaluated by magnetic solid-phase extraction coupled with inductively coupled plasma mass spectrometry determination of Hg(II) in food and water samples. Combining the advantages of magnetic separation with selective extraction of thionin towards Hg(II), the material exhibits enhanced enrich selectivity and efficiency for Hg(II). The experimental parameters influencing Hg(II) extraction efficiency, including pH of the aqueous solution, the dosage of the adsorbent, extraction time and sample volume, were systematically investigated. Under the optimised conditions, concentration of Hg(II) at 1.0 μg L^?1 can be successfully enriched by the material without the interference of the common co-existing ions. The enrichment factor and adsorption capacity were 250 and 75.2 mg g^?1, and precise of the method was confirmed by analysing the spiked food, water samples and standard water reference samples with the recoveries of 92.5–101.8%.